1:
Gather the following supplies: 3D Flower designs from the 3D Flowers Large or Small Designs (embroidered using 3D Flower Embroidering Project instructions, linked at right), Straight Pins, Floral Tape, Stem Wire (20ga Green).
2:
Bend one piece of the stem wire in half.
3:
Now wrap floral tape tightly around the stem wire from bottom to top.
4:
Hold the flower face up and poke a straight pin thru the center of the flower.
5:
Push the pin into the top of the stem wire. The end of the needle might stick out a little bit.
6:
Wrap floral tape tightly around the stem starting just under the flower and going to the bottom of the stem.
7:
This flower is complete. Repeat the above process with as many flowers as you would like to fill your vase.